Kit 16 Vintage Santa

Hi, This is kit 16 "Vintage Santa" Layout and Card.

You Need:
Kindy Glitz,
Foam tape or dots,
Staplers
& Stamp if desired.
Step 1: Cut directly in half just under the balloon, then cut it into a 10.5 inch strip from the right hand side (balloon side) and turn over to use the red Christmas paper on the other side, adhere to the cream cardctock (as per photo).
Step 2: Mount 4x6 photos onto green cardstock, then onto the black cardstock leaving 1/2 cm surround on each piece and stick down using double sided tape (see photo.)

Step 3: Cut around balloon and mount onto layout using foam tape onto the left hand side of the layout (see photo)

Step 4: From the left hand corner of pattern paper cut out 14cm x 14cm square with the Santa in the red balloon, (this will be for your card).
Step 5: Left over pattern paper will be used to create the banner, using template A cut out 4 triangles from the cream pattern paper and from template B cut 4 triangles out of the black cardstock, adhere to the cream cardstock background in a line (see photo).
Step 5: Put a thin strip of glue along the top of the banner and glue down the baker's twine and the ends as desired.

Step 6: Take the mesh ribbon and stapler to the bottom of the layout fold over and staple again repeat as desired.
Step 7: Stamp an image onto the layout on the left hand side or maybe you could put a journal tag.
Step 8: Use Kindy Glitz on the layout highlighting parts of the balloon and the banner.

To Create the card,
Step 1: Cut a 15cm x 15cm strip of the Green cardstock and fold in half.
Step 2. Adhere the square piece of pattern paper (one with red balloon Santa) to the middle of the card.
Step 3: Kindy Glitz to finish.

Thanks from the girls at Fred :-)